Duratuf D3 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Відкривач гаражних дверей Duratuf D3. Duratuf D3 20 сторінок. Roller door opener

3. PINNING THE DOOR TO THE DRUM

Pinning the door's curtain to its drum maintains security when the

opener is closed. If the curtain is not pinned the door can be

partially opened manually.

Fully close the door.

Mark a minimum of two (2) drill holes on the drum to each end

of the door.

Drill holes using 3.2mm (1/8") drill bit.

Fit M10 x 32mm screws and washers (not supplied) to each of

the four (4) holes.This screw should be positioned as low as

possible in the grove, but make sure that it does not alter the

curtain's normal lead in to the guide.

FREE DOOR

Without locking bars

door can be lifted

4. INSTALLING OPENER

The R3 roller door operator can be fixed to the roll up

garage door in a variety of ways. Described below is one

method of fixing. Make sure there is enough side room to

slide the drive assembly onto shaft.

NOTE: the instructions for fixing the operator to the

door are for right hand installations only.

Installation process (FIG. 3, FIG. 4, and FIG. 5)

Check that the door shaft U bolt is securely tightened

on the left hand side of the door.

Raise the door and tie a rope around the center to

secure the roll.

Support the right hand end of the door with a suitable

prop, e.g. step ladder and soft padding to protect door

surface.

BALLOONING DOOR

Without locking bars

door can be lifted

PINNED DOOR

Door secure and will

not lift

Screw into the

low part of

grove

Pin Points