Contempo Fireplaces PFM42 Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для Внутрішній камін Contempo Fireplaces PFM42. Contempo Fireplaces PFM42 18 сторінок. Contempo pfm series and c-thru fireplaces homeowner's guide
Також для Contempo Fireplaces PFM42: Посібник для власників житла (8 сторінок)

Друкувати сторінку

FIREBOX ASSEMBLY PROCEDURE (continued)

8. Top Front

8. Apply fireplace mortar to the top of the uppermost front section. Set the final front section in place aligning the

sides and back of the piece with the piece directly below.

9. Now the last two side top sections are ready to be set into place. Spread fireplace mortar on top of the first side

sections and also onto the front and back sections on the joining edge. Lift the side top sections into place and

adjust into place. Bolt the additional topside sections to top back section, and then remove plywood brace. Push

topside section so it fits tight to the front sections, and then bolt as indicated.

10. PFM60 Only - If the fireplace was not assembled in its final position, the 2 supplied angle irons must be secured to

the firebox before the fireplace is moved! Attach the angle irons by screwing the supplied screws through the

holes in the angle iron, and into the fireplace base. Do not over-tighten the screws.

ANCHOR PLATE/ DAMPER AND STARTER COLLAR INSALLATION

Air-Cooled Chimney: Position the

anchor plate/damper with chimney

starter collar over the opening on

the top section of the firebox, cen-

tering over the opening. Trace the

outer edge of the anchor plate. Us-

ing a ¼" masonry drill, drill into the

firebox top through the holes in the

plate. Apply a bed of refractory

mortar between the anchor plate

and top of firebox. Secure the plate

with four ¼" dia. x 2" long lag bolts.

Next install the chimney starter. Set the chimney starter over the damper, then secure the starter to the anchor

plate with supplied self-drilling screws.

12. Class "A": For class "A" insulated chimney, the damper and starter collar will be in one piece. Apply a layer of re-

fractory mortar on top of the firebox and set the damper in place. Pre-drill the holes with a ¼" masonry drill bit,

then secure with ¼" dia. x 2" lag bolts. Be careful not to over-tighten.

9. Upper Sides

11. Air-Cooled AP/Damper + Starter Collar

10. Angle Irons—PFM60 ONLY

Starter Collar

Anchor plate/

Damper

12. Class "A" AP/Damper