apivio Liberty L2 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон apivio Liberty L2. apivio Liberty L2 19 сторінок.

Друкувати сторінку

User Precautions

FCC Compliance statement

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC SAR Compliance Statement

Your wireless phone is a radio transmitter and receiver. It is designed

and manufactured not to exceed the emission limits for exposure to radio

frequency (RF) energy set by the Federal Communications Commission

(FCC) of the U.S. Government. These limits are part of comprehensive

guidelines and establish permitted levels of RF energy for the general

population.

The guidelines are based on safety standards previously set by both U.S.

and international standards bodies:

· American National Standards Institute (ANSI) IEEE. C95.1-1992.

· National Council on Radiation Protection and Measurement

(NCRP). Report 86.1986.

· International Commission on Non-Ionizing Radiation Protection

(ICNIRP) 1996.

· Ministry of Health (Canada). Safety Code 6.

The standards include a substantial safety margin designed to assure

the safety of all persons, regardless of age and health. The exposure

standard for wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The SAR limit set by the

FCC is 1.6W/kg.

Warning

· This device is for indoor use, only in the 5150~5250Mhz frequency

range.

· This device was tested for typical body-worn operations.

· To comply with RF exposure requirements, keep at least 1.5 cm

(0.5 inches) between the user's body and the headset, including

the antenna.

· Do not use third-party belt clips, holsters, or other accessories that

contain metallic components.

· Avoid use of body-worn accessories that do not meet the above

criteria, as they may not comply with RF exposure requirements.

User manual specifications and the IP Phone software version may be

updated by the manufacturer without any notice.