Contemporary Research FeatherTouch 6 Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Промисловий монітор Contemporary Research FeatherTouch 6. Contemporary Research FeatherTouch 6 9 сторінок. Contemporary research ft6 display panels: user guide
Також для Contemporary Research FeatherTouch 6: Технічні характеристики (2 сторінок)
Друкувати сторінку
RS-232 FT6 Commands
The following commands apply to the FT6.
CMD Function
L0= Turn Off
L1= Turn On
L2= On/Off Pattern >L2dd
L3= LED Polarity
L4= Group Off
L5= Group On
L9= Brightness
K
Press String
K0
Press Clear
KZ
Start String
J
Release String
J0
Release Clear
DM
Display String
V6
Show Version
Contemporary Research Corporation
Description
Note that FT6 buttons are always backlit—the button state sets color of LED. Typically,
a green LED indicates on, while yellow is used for off. Other colors are available, and
the color "polarity" can be switched via programming.
>LOn
Turns off a specific button LED, 1-6
>L1n
Turns on a specific button LED, 1-6
Turn all buttons on and off by sending a decimal representation of the on buttons.
Ex: >L2=12 — Turns on buttons 3 and 4, others are off
1 On = 1
2 On = 2
3 On = 4
>L3dd
Set the polarity (color of LED when on and off) by sending a decimal "map" of the
buttons. Off sets the normal mode, On switches on/off colors.
>L4dd
Turns off specified button LEDs. Similar to L2, but turns off specified buttons only,
leaving others alone. Ex: >L424 — turns off buttons 4 and 5.
>L5dd
Turns on specified button LEDs. Similar to L2, but turns on specified buttons only,
leaving others alone. Ex: >L524— turns on buttons 4 and 5.
>L9n
Sets LED brightness of all buttons.
1 = 13%
2 = 20%
3 = 27%
4 = 40%
>Kn(string)(\r) [use \r in place of $0D]
Set button press string (0-32 characters) for specified button, sending no characters
clears display. Ex: >K1>VU — starts STA volume ramp up
>K0 — Clears all button press strings
>KZ(string)(\r) [use \r in place of $0D] —Send string on power-up or reset
>Jn(string) (\r) [use \r in place of $0D]
Set button release string (0-32 characters) for specified button, sending no characters
clears display. Ex: >J1>VV — stops STA volume ramp
>J0 — Clears all button release strings
>DMtttttttt
Sends string to LED display, 8 characters maximum.
>V6 — Shows version on FT6 display
4 On = 8
5 On = 16
6 On = 32
5 = 53%
6 = 80%
7 = 100%
7
ICC-STA/FT6