Contemporary Research ICC1-IR Посібник з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Мережевий маршрутизатор Contemporary Research ICC1-IR. Contemporary Research ICC1-IR 17 сторінок. Ir tv controller, 1-way rf coax control
Також для Contemporary Research ICC1-IR: Технічні характеристики (2 сторінок)
Друкувати сторінку
Installation
AC Power Test
1. Insert DC power supply plug into 12 VDC jack.
2. Plug power adaptor into AC wall outlet.
3. The Net LED should turn on and stay lit.
RF Coax and iCC-Net Operation
1. Connect the TV to CATV and observe quality of RF broadcasting. A low-quality CATV system can also
affect performance of the iCC-Net commands. If needed, fix CATV problems before installing the system.
2. Connect the CATV RF Coax cable into the RF In input on the iCC1-IR.
3. If the iCC-Net signal is operating, the Net LED will blink once per second.
4. Connect the RF loop cable from the RF Out jack to the TV's RF connector (remember, you lose less than
1.5 dbmV by going through the ICC1-IR'S internal RF tap).
TV Power Sensing
1. Insert the CC-HSD Scan Sensor plug into the Power Sensor jack.
2. Turn on the TV using the TV's power button.
3. Move the CC-HSD sensor block around the rear of the TV to pick up scanning signal from the TV's
horizontal transformer.
4. Watch the Power Sensor LED as you move the sensor, stop moving when the LED lights steady.
5. Turn the TV on and off from its own power button, testing if the unit is reliably sensing power.
6. Mount the sensor to the TV, using the enclosed Velcro tape.
The best location for the sensor is usually on the lower left rear corner side corner (looking from the
Tip:
front), and it may help to rotate the sensor to search for best performance.
Some applications, such as Zenith and Philips sets with discrete power on and off, do not use the
Tip:
sensors
Contemporary Research
5
ICC1-IR IR TV Controller