Addonics Technologies ZSNESU3 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Корпус Addonics Technologies ZSNESU3. Addonics Technologies ZSNESU3 4 сторінки.

1. Be sure the lock on the drive door is in an unlock position. If

not, use the key that came with the Raid Tower to unlock the

drive door. Pull on the door lever to swing open the drive door all

the way.

2. Slide a 3.5" SATA hard drive into the drive slot with the drive

connector side facing in and the label side up. The drive should

slide all the way into the slot with very little resistance. Forcing

the drive into the slot will cause permanent damage to the drive

or the Snap-In enclosure.

3. Once the drive is all the way into the drive slot, close the door

all the way till the drive door latches securely. Lock the drive

door with the key. This will engage power and data connection

with the hard drive.

4. To remove the hard drive from the enclosure, simply follow the

step 2 – 3 in reverse.

5. Connect the power supply to the unit.

6. Connect the eSATA or USB 3.0 cable from the back of the unit

to the eSATA or USB port on the computer.

NOTE: When using the USB connection, be sure to disconnect

the eSATA cable from the back of the unit.

7. Turn on the power switch on the back of the Z enclosure.

NOTE: When connecting the unit using eSATA, the computer must be turned

off unless the eSATA port supports the hot swap feature. To determine

whether or not your computer's eSATA port supports hot swapping, refer to

the computer's user guide or its manufacturer.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/