APlusLift HW-8S Посібник з монтажу та експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Підйомні системи APlusLift HW-8S. APlusLift HW-8S 19 сторінок. 4-post portable storage car lift

Друкувати сторінку

◦

Prior to lowering the vehicle, walk around the lift and check for any objects that

might interfere with the operation of the lift and safety latches; tools, air hoses, shop

equipment, etc.

◦

Always lower the lift to the lock position before going under the vehicle.

◦

Never allow anyone to go under the lift when raising or lowering.

The following periodic maintenance schedule is the minimum requirements at the minimum

intervals. Periodic maintenance is to be performed on a daily, weekly, and yearly basis.

WARNING!! OSHA AND ANSI REQUIRE USERS TO INSPECT LIFTING EQUIPMENT AT

THE START OF EVERY SHIFT. THESE AND OTHER PERIODIC INSPECTIONS ARE THE

USER'S RESPONSIBILITY.

FAILURE TO HEED THIS WARNING CAN RESULT IN PROPERTY DAMAGE, SERIOUS

INJURY, OR DEATH. IF YOU HEAR A NOISE NOT ASSOCIATED WITH NORMAL LIFT

OPERATION OR IF THERE ARE ANY INDICATIONS OF IMPENDING LIFT FAILURE,

CEASE OPERATION IMMEDIATELY! INSPECT, CORRECT, AND/OR REPLACE PARTS AS

NEEDED.

Daily Pre-Operation Check (8-Hours)

1. Check the safety lock audibly and visually while in operation

2. Check the safety latches for free movement and full engagement with the rack.

3. Check the hydraulic connections, and hoses for leakage.

4. Check the chain connection: cracks, bent, and loose links.

5. Check the cable connection: cracks, bent, and looseness.

6. Check for frayed cables in both raised and lowered positions.

7. Check snap rings at all rollers and sheaves.

8. Check the bolts, nuts, and screws and tighten if needed.

9. Check the wiring & switches for damage.

10. Keep the base plate free of dirt, grease or any other corrosive substances.

Weekly Maintenance (every 40-Hours)

1. Check the floor for stress cracks

2. Check the hydraulic oil level.

3. Check and tighten the bolts, nuts, and screws.

4. Check the cylinder pulley assembly for free movement or excessive wear on the

cylinder yoke or pulley pin.

5. Check the cable pulley for free movement and excessive wear.

Yearly Maintenance

1. Lubricate the chains