APlusLift HW-10KBP Посібник з монтажу та експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Підйомні колони APlusLift HW-10KBP. APlusLift HW-10KBP 20 сторінок. 2-post floor plate car lift 10,000lb capacity
Також для APlusLift HW-10KBP: Посібник з монтажу та інструкція з експлуатації (16 сторінок), Посібник з монтажу та експлуатації (20 сторінок)

READ THIS BEFORE INSTALLING THE LIFT! Improper installation can cause injury or

damage!

 Read this installation and operation manual in its entirety before attempting to install

the lift. Manufacturer or distributor assumes no responsibility for loss or damage of any

kind, expressed or implied, resulting from improper installation or use of this lift. Always

use professional installation companies.

 All persons using the equipment must be responsible, qualified, and carefully follow the

operation and safety guidelines contained in this manual.

 A level floor is required for proper lift installation and operation.

 DO NOT install this lift on any asphalt surface. Recommend on concrete surface a

minimum of 6" thick and 3,500 psi tensile strength with steel or fiber mesh

reinforcement. If you always lift vehicles below 9,000LB, 4" thick concrete will be fine.

 DO NOT install this lift over concrete expansion joints or cracks. (Check with your

building architect)

 DO NOT install this lift on an upper floor without written authorization from your

building architect. Should only be installed on a ground floor without a basement.

 DO NOT attempt to lift only part of a vehicle. This lift is intended to raise the entire

body of a vehicle only. This will bend the arms and void the warranty.

 NEVER lift any persons or vehicles containing persons. This lift is designed to lift

empty vehicles only.

 Concrete rotary hammer drill with 3/4" drill bit

 Rubber hammer

 Chalk line

 Sockets and open wrench set

 Ratchet driver

 Vise grips

 Tape measure

 Screwdrivers

 Torque wrench

 Two 10' to 12' step ladders

 4' level

 12" crescent wrench

 AW32 non-foaming hydraulic fluid (4 gallons)

Important Information

Preparation