Dasan DW-770 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Гарнітури Dasan DW-770. Dasan DW-770 7 сторінок. Monaural dect wireless headset
Також для Dasan DW-770: Посібник користувача (11 сторінок)

Друкувати сторінку

When charging the LEDs on the front of the base unit will illuminate. The following

are the status and colors expected during the charging process.

Fully Charged

GREEN LEDs

Charging

RED LEDs

Operation

Before operation your headset must be paired with your base unit, this can be confirmed

by the following check :

Check GREEN status LED on base unit is ON and

Check GREEN status LED on headset periodically flash twice.

If your base unit LED is constantly flashing GREEN and your headset is flashing

constantly in RED and GREEN then you need to pair your headset with your base unit.

Pairing your Headset and Base Unit

Make sure your Base unit is turned on.

Press and hold the RX and TX VOLUME buttons on the headset at the same

time until you see the RED and GREEN LEDs on the headset flash rapidly.

Push the pairing button on the base unit in 10 seconds.

When the GREEN LEDs on the headset unit periodically flash twice and the

GREEN LED on the Base unit turns off , the units are paired.

Checking for compatibility

As telephone manufactures can vary their configuration, it is necessary to

have compatibility selections on the base unit to ensure that the DW-770 is

compatible with virtually any telephone.

To check and adjust for compatibility between the DW-770 base unit and the

telephone perform the following :

While wearing the headset – push the ON/OFF button

If you cannot hear a dial tone with the factory setting, adjust the

COMPATIBILITY switch on the base unit bottom until you hear a clear

dial tone.

When making a call, if your voice cannot be heard or is very low, adjust

the MICROPHONE SELECTION switch to the "C" position.

Making and ending call using a telephone with Lifter attached

While wearing the headset, press the ON/OFF button

Check the lifter function activates (telephone connection opens)

You can hear a dial tone

GREEN LEDs on the headset unit flash periodically flash 3 times (in-use

status) and GREEN LED on the Base unit turns on

Dial desired number

To end the call press the ON/OFF button on the headset

Check the lifter function de-activates (telephone connection closes)

GREEN LEDs on the headset will now periodically flash twice (standard

paired status) and GREEN LED on the Base unit turns off.