Apogee Instruments PYRANOMETER SP-421 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Apogee Instruments PYRANOMETER SP-421. Apogee Instruments PYRANOMETER SP-421 18 сторінок.
Друкувати сторінку
4
INTRODUCTION
Solar radiation at Earth's surface is typically defined as total radiation across a wavelength range of 280 to 4000 nm
(shortwave radiation). Total solar radiation, direct beam and diffuse, incident on a horizontal surface is defined as global
shortwave radiation, or shortwave irradiance (incident radiant flux), and is expressed in Watts per square meter (W m
-2
, equal
to Joules per second per square meter).
Pyranometers are sensors that measure global shortwave radiation. Apogee SP series pyranometers are silicon-cell
pyranometers, and are only sensitive to a portion of the solar spectrum, approximately 350 to 1100 nm (approximately 80 %
of total shortwave radiation is within this range). However, silicon-cell pyranometers are calibrated to estimate total
shortwave radiation across the entire solar spectrum. Silicon-cell pyranometer specifications compare favorably to
specifications for World Meteorological Organization (WMO) moderate and good quality classifications and specifications for
International Organization of Standardization (ISO) second class and first class classifications, but because of limited spectral
sensitivity, they do not meet the spectral specification necessary for WMO or ISO certification.
Typical applications of silicon-cell pyranometers include incoming shortwave radiation measurement in agricultural,
ecological, and hydrological weather networks, and solar panel arrays.
Apogee Instruments SP series pyranometers consist of a cast acrylic diffuser (filter), photodiode, and signal processing
circuitry mounted in an anodized aluminum housing, and a cable to connect the sensor to a measurement device. Sensors
are potted solid with no internal air space and are designed for continuous total shortwave radiation measurement on a
planar surface in outdoor environments. SP series sensors output a digital signal using SDI-12 protocol.