DaSeDa Electronics HM-710A Посібник - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник для Контролер DaSeDa Electronics HM-710A. DaSeDa Electronics HM-710A 15 сторінок. Digital feeder controller
Друкувати сторінку10. How to operate the controller
10-1. Power on / off method
This controller is a push (push) type, not a lock type.
With the AC cord plugged in
To turn on the power first, press and hold the power switch (for about 1 second)
The power turns on while it is on.
To turn off the power Turn on the power switch while the power is on in the same way
Press and hold for about 1 second to turn off the power while the display is enlarged.
In the ideal state, the button is not operated and the output is not output.
10-2. Initialize the controller
DSD_75A can initialize various parameters by button operation.
After turning off the power and holding down the "stop" button and pressing the power button to turn on the display
The power button can be released, but the "stop" button is held down for 3 seconds.
On the display
All values are initialized while flashing 3 times.
10-3. Parameter change prevention setting and cancellation
The DSD_75A controller can be set to lock the system so that it can not change various parameters such as frequency and voltage.
It is possible to prevent the setting value from being changed unintentionally when the button in use is mistakenly touched.
OFF is set in initialization. If it is set to OFF, the parameter can be changed, but if it is .
ON, the setting value will not be changed even if the volume is turned.
- To set ON, press the "RUN" button for 3 seconds while the power is on
The display flashes for 3 seconds to prevent the parameter change and turn the volume
The left-hand side flashes for 3 seconds, indicating that the current lock is in progress.
- To release the lock device again, press the "RUN" button for 3 seconds
The display flashes for 3 seconds to release the lock
You can change the parameters