Dash MANDOLINE Посібник із швидкого старту - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Кухонна техніка Dash MANDOLINE. Dash MANDOLINE 5 сторінок.

using your blade disks

Inserting

Select Blade Disk and appropriate Blade Insert (see next

page for Cutting Guide). Slide Blade Insert into Blade

Disk. *There is no Insert required if using the Shredder

Disk. For detailed instruction, refer to pg.10 of the

Instruction Manual.

Removing

To remove Blade Insert, lift Insert up and slide it off of

the Disk. For the Cube / Large Cube / Wavy Disks,

simply slide the Insert out of the Disk.

DEM001H_20190228_QUICKSTARTGUIDE_v2.indd 4-5

blade and container assembly

Make sure to place the Processing Base on

motor unit before placing the blade on base.

When placing Blade onto Processing Base,

ensuring that the tab under the Blade is inserted

into notch in the Motor Base.

NOTE: This notch will be in a different place

each time you stop the Mandoline. Pay careful

attention to make sure that the tab is inserted

into the notch and not in front of or behind

the notch.

When placing the Container under the Motor Base,

making sure to align the sides of the Container

with the slots under the Motor Base. Insert the

Container until the red arrow on the Container

lines up with the red arrow on the underside of

the Motor Base.

NOTE: There is a micro-switch under the Mandoline

that will not be activated if the Container is not

inserted properly.

3/20/19 10:50 AM