Apollo 51000-355 Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Система безпеки Apollo 51000-355. Apollo 51000-355 16 сторінок. Wireless smoke heat alarm

Друкувати сторінку

IF THE ALARM SOUNDS

• If the smoke alarm sounds, get out and stay out. Never go back inside

for people or pets.

• If you have to escape through smoke, get low and go under the smoke

to your way out.

• Call the fire department from outside your home. FOR MORE SAFETY

INFORMATION SEE THE WEBSITE: www.nfpa.org/education.

SPECIFICATIONS

• Transmitter Frequency: 345.000 MHz (crystal controlled)

• Dimensions: Ø 5'' x 2.5'' high (Ø 125mm x 63mm high)

• Weight (including battery): 8.57 oz (243 g)

• Color: White

• Spacing rating: 70ft

• Audible Signal (ANSI Temporal 3): 85dBA min. in alarm

• Sensitivity: 1.26 - 2.39%/foot

• Operating Temperature: 40°-100°F (4.4°-37.8°C)

• Supplementary heat rating: 135°F

• Relative Humidity: 15-90% Non-Condensing

• Battery (included): Three (3) AAA PC2400 Duracell Procell or three (3)

AAA Energizer E92 batteries

• Regulatory Listing: UL 217

• Warranty: Two (2) years

• Included Accessories: Mounting Hardware Package

REGULATORY INFORMATION NOTICE:

Unauthorized changes or modifications could void the user's authority to

operate the equipment.

This device complies with Part 15 of the FCC Rules and Industry Canada

licence-exempt RSS standard(s). Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that

may cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate

radio frequency energy and if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/television technician for

help

"For your information, The National Fire Alarm Code, NFPA 72, reads as

follows:

"11.5.1 Required Detection."

"Where required by applicable laws, codes, or standards for a specific type

of occupancy, approved single- and multiple-station smoke alarms shall be

installed as follows:

1. In a sleeping rooms and guest rooms

2. Outside of each separate dwelling unit sleeping area, within 6.4 m

(21 ft) of any door to a sleeping room, the distance measured along

a path of travel

3. On every level of a dwelling unit, including basements

4. On every level of a residential board and care occupancy (small

facility), including basements and excluding crawl spaces and unfi

nished attics

5. In the living area(s) of a guest suite

6. In the living area(s) of a residential board and care occupancy.

(Reprinted with permission from NFPA 72®, National Fire Alarm Code

INST APD0601 C160927