4DRC 4D-V25 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Квадрокоптери 4DRC 4D-V25. 4DRC 4D-V25 16 сторінок.

8.2 Press and hold the power switch button of the

remote control

of the remote control will be on; push the throttle

lever up to top (step 2) and then to the end (step 3),

code-matching will succeed, and the aircraft light

will change from flashing to be always on.

It must ensure that the power of the aircraft/remote control is sufficient or it

Warning

cannot take off!

8.3 Horizontal calibration operation:

Long press the calibration key on the remote controller,

flash. When the LED lights on, calibration of the aircraft is completed, the remote controller emits

"beep" (Figure 1).

Note: The calibration must be completed only when the aircraft is placed on a horizontal plane.

8.4 Start/stop

Push the left control lever on the remote control upward (Figure 2). At this time, the aircraft can take

off normally. After taking off, all the indicator lights of the aircraft will always be on. During the flight,

whether you short press the

Note: This function operation is only suitable for the aircraft in an uncontrolled state. Under normal

circumstances, it is recommended to use the one-key takeoff/one-key landing

(step 1), and the power indicator

Figure 1

key, the aircraft will stop flying (Figure 3).

Figure 2

and the LED lights on the aircraft will

Figure 3

key.