Durendall Distract-Ball Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Датчики безпеки Durendall Distract-Ball. Durendall Distract-Ball 4 сторінки. Non-explosive distractionary device
Друкувати сторінку
Depressing the external Activate Button Arms the DISTRACT-BALL®. Once Armed, the
programmed distracting sequence is activated through the internal Micro-Controller Unit
(MCU).
Following the Arming event, user feed back is supplied via 2 soft audible clicks for the
device. This alerts the user that the DISTRACT-BALL® is Armed and ready to be
deployed. If in the event that the device has been Armed and the user would like to abort
further operation, simply depressing the Activate Button TWICE, will disable any further
distractionary operations from occurring.
After the 2 confirmation clicks, an approximately 2 second no-activity delay commences: it
is during this time that the user would normally throw/roll/deploy the DISTRACT-
BALL® in the intended target environment. The DISTRACT-BALL's high power
speaker starts emitting a 110dB siren like sound at approximately 3KHz for approximately
7 seconds. At this same time, the high intensity CREE LEDs are turned on into a
maximum light output Strobe stage while the high power speaker continues to emit sound.
Subsequently, the device stops emitting sound and the lighting becomes constant with 80%
illumination output: in this mode the device is intended to allow a lighted environment
search. The DISTRACT-BALL® will continue to reduce it's light output over time to
approximately 50% of maximum, allowing the environment to be continuously lit, and the
device to be easily retrieved by the user.
The DISTRACT-BALL® can then be de-activated by depressing the Active Button twice.
Now, the DISTRACT-BALL® is ready for the next distracting sequence!
The DISTRACT-BALL® employs rechargeable batteries for an always-ready state. The
batteries can be simply charged via the external charging port and can be activated up to
fifteen times on a single charge. For optimal results, the device should be re-charged after
every use, or extended periods of inactivity, for a minimum of four hours.
Instructions for Use:
Instructions for Use:
Instructions for Use:
Instructions for Use:
1. Please completely charge the device before its first use. Insert the USB cable prong
into the unit's micro power connector and connect the cable with the wall charger.
Charge the device for four hours minimum before first use. The DISTRACT-
BALL® has proven to be capable of operating for many times on a single charge
but we suggest re-charging the unit after each use, when possible.
2. PROPER MODE OF USE
PROPER MODE OF USE:
PROPER MODE OF USE
PROPER MODE OF USE
a. The DISTRACT-BALL® should be used for distracting purposes and as a
means of illuminating searching areas, only.
b. It should NEVER be used as a toy or deployed while participating in a
game.
i. Warning! The DISTRACT-BALL® should never be placed
ii. Warning! The DISTRACT-BALL® should never be held up to the
directly in front of the eyes as permanent damage to the eyes may
occur.
ears as permanent hearing loss may occur.
Page 2 of 4