Data Harvest 1207 Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Датчики безпеки Data Harvest 1207. Data Harvest 1207 20 сторінок. Wireless uv sensor

1207 – Wireless UV Sensor

Charging the Sensor

The Smart Wireless sensors are fitted with a rechargeable lithium-ion battery and can be charged via

the USB port. Use the supplied USB lead to connect the sensor either directly to a USB port on your

computer, a powered USB hub or a USB mains charger that outputs 5 V at 500 mA or more.

A full charge can take up to 4 hours.

Additional Information

Whenever the sensor is connected to the USB port on the computer or to a USB mains charger (output

5 V at 500 mA or more), it will automatically recharge the battery (LED status flashing white).

When connected to a computer, the computer should be turned on and not in sleep or standby mode,

as the battery may drain instead of charge.

The sensor will stay awake for 5 minutes when Bluetooth advertising (LED status flashing blue).

Lithium-ion batteries are 'memory-free' and prefer a partial rather than a full discharge. Constant partial

discharges with frequent recharges will not cause any harm. Frequent full discharges should be

avoided whenever possible. Ideally the sensor should be stored at about 40% or more charge.

The speed at which a lithium-ion battery will age is governed by both its storage temperature

(preferably less than 40 ̊ C ) and state-of-charge.

9 / 20 | Revision: 0 | DS182