DURKOPP ADLER 806 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Аксесуари для швейних машин DURKOPP ADLER 806. DURKOPP ADLER 806 19 сторінок.
Друкувати сторінку
3.3
Fitting the covers above the table
3.4
Fitting the covers below the table
Make absolutely sure to assemble the covers in the order described
below.
Cover 1 folding station
–
Put the cover in place from above.
At the same time pay attention to the control-panel guide.
–
Put the control in place from above.
–
Fix the control using the fixing screws.
Cover 5 carriage
–
Put on the cover from above so that it is nested in the
folding-station cover.
Cover 6 sewing head
–
Put the cover into the guide of the carriage cover from the right.
–
Insert the reel stand from above.
–
Tighten the fixture on the reel stand.
–
Secure the cover with the lock.
Cover 10 on the left at the back and cover 11 on the right at the
back
–
Put the cover into the guiding hooks below.
–
Pull the cover up and insert it into the guiding hooks above.
The cover is locked by the springs on the lower guiding hooks.
Cover 4 on the left at the front and cover 7 on the right at the front
–
Pull the covers up and remove them towards the front.
–
Secure the cover 7 with the lock.
Cover 2 left-hand side
–
Put the cover into the guiding hooks below.
–
Pull the cover up and insert it into the guiding hooks above.
The cover is locked by the springs on the lower guiding hooks.
–
Assemble the stacker plates.
Cover 9 right-hand side
–
Put the cover into the guiding hooks below.
–
Pull the cover up and insert it into the guiding hooks above.
The cover is locked by the springs on the lower guiding hooks.
–
Secure the cover with the 2 locks.
Cover 8 Stacker
–
Swing the stacker forward.
–
Put on the cover from above.
–
Tighten all 7 fixing screws.
–
Swing the stacker back.
9