Cavalli Audio Liquid Carbon Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Підсилювач Cavalli Audio Liquid Carbon. Cavalli Audio Liquid Carbon 15 сторінок. Balanced transportable headphone amplifier

Друкувати сторінку

Headphone Outputs

The Liquid Carbon® Balanced Transportable Headphone Amplifier is equipped with one 4 Pin

XLR output, one 4 Pin RSA (Kobiconn) output, and one TRS (Phone). All three output jacks are

on the front panel.

4 Pin XLR

This jack supports headphones wired with a 4 Pin fully balanced connector. This jack is

labeled above the round jack with the letters "bal".

CAUTION: do not connect headphones with a 4 Pin XLR which has a common ground (3

wire) connection to the headphones. This will absolutely damage the amplifier and

void your warranty.

RSA (Kobiconn) Jack

This mini 4 pin balanced jack is located on the front panel to right of the TRS jack. The

jack is also labeled "bal" with a headphone symbol above.

TRS Jack

One ¼" TRS jack is located on the front panel of the amp. This jack is labeled above with

the letters "se". Note that this output, using half of each amplifier, supplies only ¼ the

power of the balanced output.

Recommended Mode of Operation

The Liquid Carbon amplifier can run with singled ended input

and single ended output or a combination of single ended and

balanced. However, to get the best performance from this

amplifier we recommend that you operate in fully balanced

mode from input to output

Page 7 of 15