4IPNET EAP701 Посібник зі швидкого встановлення - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Бездротова точка доступу 4IPNET EAP701. 4IPNET EAP701 18 сторінок. Enterprise access point
Друкувати сторінку
Click on the Wireless button on the main menu.
Select the Repeater tab.
Choose WDS as the Repeater Type.
Choose the desired RF card and WDS profile:
(a) Enable WDS.
(b) Enter the MAC Address (peer AP) and then Click SAVE.
If you are using another EAP701 as the peer AP, simply repeat the above-mentioned steps to configure
another peer AP(s).
On each and every configuration page, you may click SAVE to save the changes of your configured
settings, but you must reboot the system for the changes to take effect. After clicking SAVE, the
Note:
following message will appear: "Some modifications have been saved and will take effect after
Reboot."
Congratulations!
Now, 4ipnet EAP701 is installed and configured successfully.
After EAP701's network configuration is completed, please remember to change the IP Address of
your PC Connection Properties back to its original settings in order to ensure that your PC functions
properly in its real network environments.
It is strongly recommended to back up your configuration settings.
For further configuration and information, please refer to the User's Manual.
Copyright © 4IPNET, INC. All rights reserved.
EAP701 Enterprise Access Point
13
Quick Installation Guide
ENGLISH
P/N: V10020141229