Cavity Sliders SofStop Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень Cavity Sliders SofStop. Cavity Sliders SofStop 4 сторінки.

Друкувати сторінку

Insert the track stops.

Once the door is installed and running smoothly, insert the

track stops into the track (if not already fitted) and tighten in the

correct location.

Adjust the door height.

When adjusting door height, the wrench should be horizontal to

the nut.

Use the small end of the wrench supplied to adjust the door for

height and plumb.

To raise door: Rotate wrench from left to right.

To lower door: Rotate wrench from right to left.

Adjusting

wrench

Note: The top of the hanger pin screws into

a self-locking Nyloc type nut in the carriage. For the assembly

to remain in its adjusted position over time the hanger pin must

be screwed into the nylon locking portion of the nut by at least

3 full turns. (The thread gets harder to turn once it reaches the

start of the nylon locking ring).

If you raise the door to the maximum height position, the

threaded bolt may contact fixing screw heads. If required,

remove hanger bolt from wheel and remove 2-3mm (1/8") of

thread.

Longer hanger pins are available if more height adjustment is

required.

Set the activator position.

Single & Twin

a) Slide the activator into the track through the activator slot

and position it about 20" back from the end of the track

that you want to soft close.

Do not tighten grub screws.

Turn nut to adjust

To raise

door

To lower

door

b) If the end of the track does not butt up to the

wall, use a straight edge.

Hold the activator setting block on the straight

edge or finished wall and gently close the door

onto it.

The activator will slide along the track into the

correct position.

Activator

setting

block

Straight

edge

c) Open the door and remove the activator setting block.

Without moving the activator, tighten all four grub

screws.

d) If you have a twin mechanism (soft close & soft open),

you will need two activators. Repeat the steps above

for the other end.

Attach the fascia and end caps.

Remove protective tape from fascia if applied.

Insert top leg of fascia (A) into the recessed groove at the

top of the track extrusion.

Push down firmly until middle leg (B) clips into groove (C)

along the bottom of the track extrusion.

Screw end caps into screw tubes inside track and fascia

extrusions as shown using screws provided.

End cap

Door

Fascia

Go to page

(overleaf)