Elsema PentaTimer PCR43302240T Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Приймач Elsema PentaTimer PCR43302240T. Elsema PentaTimer PCR43302240T 7 сторінок. Two channels, 433mhz penta receiver with time clock functions
Друкувати сторінку
PentaCODE Programming Instructions
12- Way Dip Switch Coding
1. Set a random code on the receiver dip switch by flicking the dip switches "On" or "Off".
(DO NOT USE THE DEFAULT FACTORY SETTING FOR THE 12-WAY DIP SWITCH AS THIS
IS A COMMON CODE)
2. Open the battery cover in the PentaCODE® remote.
3. Match the 12-way dip switch to the receivers 12-way dip switch.
4. Press button 1 on the remote and the receiver output should activate. This is indicated by the receiver
LED.
To program the same PentaCODE® remote buttons 2, 3 or 4 to another receiver change dip switch 11 and 12 in
the 2nd, 3rd and 4th receivers. For example:
Receiver 1
Receiver 2
Receiver 3
Receiver 4
Dip switches 1 to 10 should all be the same in the remotes and the receivers.
Encrypted Coding - (All 12-Way Dip Switches must be "Off")
Coding the PentaCODE® remotes and receivers can be done in 3 different ways.
3. Receiver to a Remote
4. Remote to a Receiver
5. Remote to a Remote
Receiver to a Remote
1. Press and hold the program button 1 on the receiver.
2. Press the remote button you want to program for 2 seconds, receiver LED will flash Green
3. Release the button on the receiver and the remote.
4. The LED on the PentaCODE® remote will flash to confirm the coding has been successful.
Remote to a Receiver / Remote to a Remote
Set one of the remotes or receivers to broadcast its code. The broadcaster's code will be programmed to the
other units.
- To broadcast the remotes code make sure all 12 dip switches are "off". Then press and hold button 1 and
flick dip switch 12 "on" and then "off". This is confirmed by the LED's being on for 10 seconds. You can
release the remotes button 1.
- To broadcast the receivers code make sure all 12 dip switches are "off" and then flick dip switch 12 "on"
and then "off". This is confirmed by the green LED being on for 10 seconds.
While broadcasting the code press button 1 on a different remote or receiver for 1 second and then release
the button. The LED will flash twice to confirm successful programming.
Broadcasting will be latched on for 10 seconds or stop if any dipswitch is turned on.
Deleting Receivers Memory
Short the CC pin on the receiver for 10 seconds.
Receivers Dip Switch 11
Off
On
Off
On
This will delete all the remotes from the receivers memory.
2 Channel, Penta Receiver with Time Clock
Receiver Dip Switch 12
Off
Off
On
On
ELSEMA