Elsema FMT-302 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Передавач Elsema FMT-302. Elsema FMT-302 7 сторінок. 27mhz remote control digital transmitter

Using FMT-302 and FMT-304

To Use FMT-302 with a 2 channel receiver, and FMT-304 with a 4 channel receiver, just match the 10 way

dip switch on the transmitter to the receiver.

Using 2 Different Receivers with FMT-302

FMT-302 can also be used with 2 different single channel receivers e.g. FMR-212.

Make sure the 10 way dip switch on the transmitter board matches the first 10 dip switches on the receiver.

Set the receivers dip switch 11 and 12 as described below.

When Button A is pressed, dip Switch 11 is transmitted as "ON" (Dip switch 11 on the Receiver is up)

When Button B is pressed, dip Switch 11 is transmitted as "OFF" (Dip switch 11 on the Receiver is down)

When wire link is connected (Factory default), dip switch 12 is "ON" (Dip switch 12 on the Receiver is up)

When wire link is disconnected (cut), dip switch 12 is "OFF" (Dip switch 12 on the Receiver is down).

(see picture below for the location of the wire link)

Using 4 Different Receivers with FMT-304

FMT-304 can also be used with 4 different single channel receivers e.g. FMR-212. This can be setup as follows:

1. Make sure the 10 way dip switch on the transmitter board matches the first 10 dip switches of the

receiver.

2. The receivers dip switch 11 and 12 configuration is illustrated below.

The channel coding figure can be found at the back of the battery cover.

1,2,4 Channel, Handheld 27MHz Remote Control Digital Transmitter – FMT-301,FMT-302, FMT-304

- 6 -

ELSEMA