Elsner Suntracer KNX basic Series Технічні характеристики та інструкція з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Технічні характеристики та інструкція з монтажу для Метеостанція Elsner Suntracer KNX basic Series. Elsner Suntracer KNX basic Series 12 сторінок.
Друкувати сторінку24 V DC version
1
5
6
2.2.5. Mounting the sensor
Close the housing by putting the cover back over the bottom part. The cover must snap
in on the left and right with a definite "click".
Weather Station Suntracer KNX basic • Status: 15.07.2013 • Technical changes reserved. Errors reserved.
2
3
Fastening
9
Installation and commissioning
Fig. 12
4
1
Slot for cable connection to
the rain sensor in the housing
cover
2
Tension clamp for voltage
supply (24 V DC/20 V AC).
Massive conductors of up to
1.5 mm² or conductors with
fine wires. Terminal configu-
ration independent from po-
larity (+/- or -/+).
3
Opening for the cable for the
voltage supply and for bus ca-
ble
4
Slot for KNX clamp +/-
5
Programming pushbutton for
the teach-in of the device
6
Programming LED
Fig. 13
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed sensor from under-
neath.