Dusol DS36M Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Сонячна панель Dusol DS36M. Dusol DS36M 11 сторінок.
DUSOL Solar Photovoltaic module
MADE IN DUBAI
1. General Information
1.1 Over view
Thanks for choosing DUSOL Solar PV modules. In order to ensure the PV modules to be installed
correctly, please read the following operation instructions carefully before installing and using the
modules.
Please remember that the products would generate electricity and certain safety measures need to be
taken to avoid danger.
1.2 Introduction
This User Manual refers to the installation, wiring, handling, maintenance and general administration
of our PV-modules. Please read this manual accurately and completely before configuration and
installation of the PV-module. All advices given in this document are to be handled by a qualified
person. Attention should also be paid to the live threatening risk, which may occur because of the
tension in conjunction with a grid-feeding PV-plant. In case of an improper installation of the module
there is a danger of fire risk.
In case of divergence towards this user manual DUSOL does not incur liability for personal damages
or property damages, which arise because of improper utilization, maintenance or incorrect assembly
of the photovoltaic module.
1.3 Applicable Products
This document is applicable to the series of solar module as listed below:
DS36M (150=40-170, in increment of 5)
DS60M (250=250-280, in increment of 5)
DS72M (300=170-350, in increment of 5)
DS36W (150=40-170, in increment of 5)
DS60W (250=250-280, in increment of 5)
DS72W (300=300-350, in increment of 5)
Make sure the array of modules installed within the Maximum permitted system voltage and the
rating current and voltage of the sub-equipments such as regulators and inverters. The maximum
permitted system voltage (DC) of the modules is 1000V. This module has a Class C Fire Rating and
must be installed over a roof which is with appropriate fire resistance.
The modules are qualified for application class A, and modules qualified for safety through EN IEC
61730 within this application class are considered to meet the requirements of Safety Class II
3