Dust Networks D2120 Посібник із швидкого старту - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Блок управління Dust Networks D2120. Dust Networks D2120 18 сторінок. Evaluation kit

Друкувати сторінку

2 - S

HAPTER

MART

ESH

ANAGER

Connections

The D2120 SmartMesh Manager has the following ports available:

Serial port 1 (DB9-M)

Figure 2-2. SmartMesh Manager Connectors

Technical Specifications

Table 2-1. Technical Specifications for SmartMesh Manager

•

—Used for connection to a LAN or direct connection to a

10/100 Ethernet port

computer using the cross-over cable provided in the D2120 Evaluation Kit. Refer to

the SmartMesh Manager Administration Guide for information on configuring the

IP address of the SmartMesh Manager.

•

—Reserved for future connection. 115 kbps maximum. Not

Serial 1 port (RS232)

flow controlled (TX, RX, ground only).

•

—Command line interface (38400 bps, 8 data bits, no parity,

Serial 2 port (RS232)

1 stop bit. Not flow controlled (TX, RX, ground only).

•

—5 VDC, center positive, 2A.

Power

10/100 Ethernet

Connection