Dustbane 19677 Посібник з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Повітродувка Dustbane 19677. Dustbane 19677 16 сторінок. Gladiator series

15. Cleaning and Servicing the Filters

The filters are very important components of the machine and essential for correct operation. Proper filter

maintenance will allow you to obtain the best performance from your machine.

Pre-Filter

Clean Daily

1. Remove the debris hopper to access the pre-filter

2. Release the two metal retaining clip arms that secure the pre-filter in place. Hinge the retaining clip arms

outward and remove the pre-filter.

3. Shake the pre-filter into a debris receptacle.

4. Replace the pre-filter and secure with retainer clips.

Main Filter

The Main filter can be cleaned in any of the following three ways:

1. by means of the automatic filter shaker:

During operation, the machine will automatically activate the filter shaker every 3 minutes.

2. by means of manually activating the filter shaker:

Just a simple command is needed to keep the filter in perfect working order: press the button

marked 'E' and hold it down for a few seconds. Repeat this operation 4 or 5 times. Remember that

the cleaner the filter, the better the results of your cleaning session. It is recommended to

carry this operation out at the end of each work cycle.

NOTE: dusty environments If you are using the machine in a dusty environment it is a

3. by manually cleaning the filter:

Manually clean the filter when the filter shaker is not enough to keep the filter clean and/or every

20 hours of work. Before carrying out any kind of procedure on the machine, make sure it is

turned off and that all functions are deactivated

1. Remove the rear hopper

2. Take the filter out

3. Blow compressed air into the side of the filter (at a pressure of 87 psi at the most). Safety glasses required

4. Reinstall the filters and the rear hopper.