Datalogic DS2100N Короткий довідник - Сторінка 17
Переглянути онлайн або завантажити pdf Короткий довідник для Сканер Datalogic DS2100N. Datalogic DS2100N 20 сторінок. Compact laser scanner
Також для Datalogic DS2100N: Брошура та технічні характеристики (2 сторінок)
Друкувати сторінку
COMPLIANCE
LASER SAFETY
This product conforms to the applicable requirements of IEC 60825-1
and complies with 21 CFR 1040.10 except for deviations pursuant to
Laser Notice N° 50, date June 24, 2007. The scanner is classified as a
Class 2 laser product according to IEC 60825-1 regulations.
Disconnect the power supply when opening the device during
maintenance or installation to avoid exposure to hazardous laser light.
There is a safety device, which allows the laser to be switched on only
if the motor is rotating above the threshold for its correct scanning
speed.
The laser beam can be switched off through a software command (see
also the Genius Help On Line).
The laser diode used in this device is classified as a class 3B laser
product according to EN 60825-1 regulations and as a Class IIIb laser
product according to CDRH regulations.
Any violation of the optic parts in particular can cause radiation up to
the maximum level of the laser diode (35 mW at 630 to 680 nm).
AVOID EXPOSURE LASER LIGHT
IS EMITTED FROM THIS APERTURE
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of Datalogic could void the
authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or
LPS power source, which supplies power directly to the scanner via the 25-pin connector.
CE COMPLIANCE
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
DS2100N QUICK GUIDE
Complies with 21 CFR 1040.10
except for deviations pursuant
to Laser Notice N°50,
date June 24, 2007
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO IEC 60825-1:1993+A1:1997+A2:2001
CAUTION-CLASS 3B LASER LIGHT
WHEN OPEN AVOID EXPOSURE TO BEAM
Pat. US5992740, EP0789315B1
DATALOGIC AUTOMATION S.r.l.
Via S. Vitalino, 13 – 40012 Calderara di Reno
MADE IN ITALY-www.datalogic.com
Figure 12 - Warning and Device Class Labels
17