Dusty Strings Dusty Harp Pickup P20 Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Музичний інструмент Dusty Strings Dusty Harp Pickup P20. Dusty Strings Dusty Harp Pickup P20 5 сторінок. For lever harps
b.
Remove the rubber end cap.
c.
Turn the thumb screw on the stop collar counterclockwise to loosen. Slide
the stop collar off of the leg.
d.
Remove the rubber O-ring from the leg.
e.
Loosen the locking knob on the base of the harp and remove the leg.
Step 2: Drill Jack Hole
Note: Don't want to drill a hole in your harp? Dusty Strings offers a
no-drill solution for mounting your pickup jack to your harp. The Dusty
Pickup Jack Clamp may be used to eliminate the need to drill a hole in your
harp. See more at www.dustystrings.com.
Owners of Ravenna models may have a hole pre-drilled in their harp. Check for an existing hole covered by a black plastic
cap near the bottom of the left quarter stave (the angled panel to the left of the back of the harp). If you have a pre-drilled
hole, remove the cap and skip to Step 3 – Mark Pickup Element and Harness Clip Locations.
1.
Find the center of the jack hole for your harp in the table below.
Ravenna 26 & Ravenna 34
FH26 & Allegro 26
Crescendo 34, FH34,
Crescendo 32 & FH32
FH36S, FH36H & FH36B
2.
Using an awl, mark the position of the center of the hole on the back of the harp.
3.
Place a folded paper towel inside the harp to collect dust and wood chips from
the drilling.
Caution: When drilling, use gentle pressure to avoid chipping out the back of the hole
and to prevent the drill from plunging through and damaging the soundboard.
4.
Carefully drill a hole with a ½
keep the drill bit perpendicular to the surface of the harp.
Note: Using a brad-point drill bit is important. This type of bit centers
the hole and holds the bit in place, helping to prevent damage caused
by the drill bit sliding on the surface of the harp. It can also help to
ensure that the hole doesn't get "wowed out" as you drill. If needed, ½"
brad-point bits are available from Dusty Strings.
5.
After drilling, make sure the inside edge of the hole is free of splinters.
Left Quarter Stave, 1½" up from base and centered on the
panel left to right
Center of back, 1⅛" below bottom sound hole
Center of back, 4" below bottom sound hole
Center of back, 5" below bottom sound hole
" brad-point drill bit (see figure 3). Be sure to
Figure 2 – Ravenna Drop-Down Leg
2
End cap
O-ring
Locking
knob
1½"
Brad-point
Standard
drill bit
drill bit
Figure 3 – Drill bits
Stop
collar
1⅛"
4"
5"