DUTCH IM2.3 Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Обладнання для запису DUTCH IM2.3. DUTCH IM2.3 4 сторінки.

Inserts:

Rearpanel:

The IM2.3 has 8 inserts connected on the back with industry standard Tascam DB25 analog

connectors. Each connector holds 2 inserts corresponding with the frontpanel numbering.

Be careful with DB25 tascam standard premade cables. The digital AES/EBU cables like the

Hosa AES-803T have their XLR's connected in the wrong way which swaps send/return.

Though it's an easy fix (swap male and female), you might want to look at this carefully.

Insert 1 and 2:

This is a 100% passive insert section with just relays. When disabled, it will directly pass

the signal internally to the next stage. When you enable the insert (1 and/or 2), it will pass

the signal to the corresponding send/return. It will first pass insert 1 and then it goes into

insert 2. When you push the 'swap 1 /2 button, it will swap the order of the inserts. So

instead of 1>2 it will be 2>1.

Insert 3 and 4:

Insert 3 and 4 are the same as insert 1 and 2.

Insert 5 and 6 (mid/side):

Insert 5 and 6 are more special, they can be used for Mid/Side processing.

When set to stereo, it will be 100% passive and it will not pass the active MS circuit at all.

The active MS circuit is based around THAT and BurrBrown chips and is an extended

version of the Wayne Kirkwood circuit.

Mid Side:

When the MS button is engaged, both inserts 5 and 6 will work in MS mode. Left channel is

Mid (sum), Right channel is Side (diff). When the width switch is disabled, no gain changes

are done on mid or side. But you should keep in mind that the sum (mid) will be louder

then the side channel because of the LR summing/gain buildup. So you should be careful

with 'distortion sensitive equipment' but in practice this will not lead to any problems.

Width:

When you enable the width button, the width circuit becomes active and you can change

the gain of the side channel, making it more wide or narrow. I choose to take it out of the

circuit because of the extra stage needed to take care of the width control and also for

AB'ing. I picked a default gain range of +/- 3dB up with 23 steps. In practice you will not