Datapath The VisionAV-SDI Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для PCI карта Datapath The VisionAV-SDI. Datapath The VisionAV-SDI 14 сторінок. Three channel audio and video capture card
Також для Datapath The VisionAV-SDI: Посібник (2 сторінок)
Друкувати сторінку
Installing the Capture Card
You are likely to need a flat blade and/or a cross head screwdriver for the installation of the
VisionAV-SDI card; it would be useful to have these to hand before you begin.
• Power down the PC (including peripherals), switch off at the mains and disconnect all the cables
connected to the computer, noting the positions for accurate reconnection
• Remove the PC cover
• Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate
(retain all screws)
If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If
the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is
powered up and the warranty will be void
• Reconnect all cables to the PC then connect a DVI cable (not supplied) distributing the DVI source
signal to the connector on the VisionAV-SDI capture card
• A standard definition signal can be connected to the RCA connector on the VisionAV-SDI
• An SDI signal can be connected to the BNC connector
• Power up the PC and commence the software installation
How to Connect Input Sources
The VisionAV-SDI card has one DVI-I, one RCA (female) connector and one BNC (Green LED) connector.
The DVI-I connector supports DVI, HDMI, Component and RGB (VGA) inputs using the supplied adapters
where required.
A DVI input is connected directly into the DVI-I connector which accepts DVI-D (digital) or DVI-A (analog)
inputs:
An HDMI input is connected to the DVI-I connector using the supplied DVI-HDMI Adapter:
5