DUUN TFP250 Інструкція з експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Снігоочисник DUUN TFP250. DUUN TFP250 18 сторінок.

Друкувати сторінку
Before cleaning, lubricating, repairing or adjusting the machine, stop the engine and activate the
handbrake, and remove the key during work. Close the safety crane on the snow blower that
closes the oil on the operation of the feeder screw.
Pay special attention to safety during maintenance work, park the machine in according with
specified safety rules.
Inspection after screw connections
Screws - nuts - fittings and bolts on the machine should be re-tensioned after two hours of
operation. All moving parts should be lubricated with grease.
The ejector spout's swivel is exposed to both cold and heavy wear - therefore use cold-resistant
grease that can handle up to -40 degrees.
Wear steel and skid pads are exposed to heavy wear - check and carry out the replacement or
reversal of wear steel before damage occurs to the hull itself and mounting brackets.
Remove snow after use so that icing does not cause any problems at start-up later.
To extend the life of the machine, cleaning after use is recommended. Do not flush water directly
into the bearing. For long-term storage, it is recommended to lubricate the machine in acid-free oil.
Interval of lubrication and grease quality
Bearing for the front fan (1 pcs.)
Interval:
Every 100 hours and when parking in the spring.
Avoid pushing in too much grease as this can cause sealing rings to squeeze
out + contribute to overheating of the entire bearing.
The recommended amount of 7-8 grams per time.
Bearing for the feed screw (2 pcs.)
Interval:
Every 100 hours and when parking in the spring.
Avoid pushing in too much grease as this can cause sealing rings to squeeze
out + contribute to overheating of the entire bearing.
Recommended amount of 7-8 grams per time.
Bearing for the operation of the feeder screw (2 pcs.)
Interval:
Every 100 hours and when parking in the spring.
Avoid pushing in too much grease as this can cause sealing rings to squeeze
out + contribute to overheating of the entire bearing.
The recommended amount of 7-8 grams per time.
Expiration spout for ball bearing
Interval:
Every 50 hours. Use low temperature grease Statoil uniwai LIX 42 or equivalent.
Sprocket on outlet spout
Interval:
When needed.
Power transmission shafts – universal joint + telescopic tube
Every 8 – 10 operating hour.
Interval:
Maintained according to the attached instruction manual. Please contact the supplier if this is
missing.
Grease quality: Universal grease of good quality.
15