Datapath Arqa TX1/C Посібник із швидкого старту - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Приймач Datapath Arqa TX1/C. Datapath Arqa TX1/C 12 сторінок.

Arqa Quick Start Guide

Connect the Arqa RX1 and the TX1 as follows using the connection illustrations as a guide:

Connect both the Arqa RX1 and the TX1 to the 12V 1A power supply provided.

Connect the USB cable (provided) to a USB port on the PC and to the USB port on the Arqa TX1.

Connect a keyboard and mouse to the USB ports on the Arqa RX1.

Connect the Arqa RX1/C and TX1/C using a CAT5e/6 cable (not supplied).

Connect the Arqa RX1/F and TX1/F using a fiber cable (not supplied) connected to the SFP

modules in each unit.

Connect the graphics output of your PC to the DVI In port of the Arqa TX1 using the supplied HDMI

to DVI video cable.

Connect the DVI Out port of the Arqa TX1 into a local monitor if required. You can use the supplied

DVI/HDMI adapter to reconnect your original HDMI cable back into the HDMI input of your local

monitor.

Connect the Arqa RX1 DVI Out port to the remote monitor using the video cable supplied with

your monitor and the DVI/HDMI adapter supplied with your RX1 receiver.

If using a network switch, connect all endpoints from the units to the switch. Ensure that all

connections have a minimum bandwidth of 1 Gbit/sec. For video sharing the network switch must

support IGMP snooping.

STEP 2 ATTACHING THE ARQA TX1 UNITS TO THE RMK

Attach the Arqa TX1 to the faceplate by removing the top left and bottom right screws (1). Align the

blank screw holes on the faceplate (2), then insert the screws to lock the Arqa TX1 units in place.

RMK