Dataprobe iPIO-8 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Dataprobe iPIO-8. Dataprobe iPIO-8 2 сторінки. Ethernet i/o monitor and control
Також для Dataprobe iPIO-8: Посібник (15 сторінок), Посібник із швидкого старту (2 сторінок)

Друкувати сторінку

What's Included



iPIO-xx Unit



Network Cable



Quick Start Guide



A/C Power Supply

Connections

Connect Network.

5) cabling. When power is connected to the iPIO, the green Activity LEDs on the network connector indicates when the

network connection is properly established.

Connect Inputs.

Connect the inputs to the iPIO using the screw terminals.

Inputs can be either dry relay or switch contacts, or a +VDC

voltage (3 to 30 V), referenced to a common ground.

Screw terminals are removable for easy installation.

Terminals for each circuit are marked + and G.

connecting dry relay contacts, the polarity is not significant.

Connect Relays.

Relays are Form C.

Normally Closed (NC) and Normally Open (NO) as

marked. When the iPIO-8 relay is in the Open Condition,

the Common is connected to the Normally Open. In the

Closed state, the Common and Normally Closed are

connected.

Connect Power.

Power supply.

power up the iPIO device. The iPIO-2 supports Power

over Ethernet (PoE). Consult the complete manual for more details.

IPIO quick start

Quick Start Guide

iPIO supports 10/100 Ethernet using the cable supplied, or other suitable unshielded twisted pair (Cat

(2 Connections per Channel)

(3 Connections per Channel)

Connect to the Common (C),

Each unit is supplied with a n A/C

Connect to suitable A/C source, then

Available Online at

dataprobe.com/support-ipio



When

Relay Specifications

Rating (resistive)

Max Carrying Current

Max Switching Power

Max Switching Voltage

Max Switching Current

Life Expectancy

Complete Product Manual

Device Management Utility

Latest Firmware

Software Developer Tools

The iPIO is Factory set for Dry

Contact Input Only.

Prior to Connecting +VDC, Jumpers

must be configured.

See full manual or contact Dataprobe

Technical Support.

0.5 A 120 VAC or

1 A 24 VDC

2 A

60 AV, 24 W

120 VAC/60 VDC

5 Million Operations Mech.

100K Oper. at rated load

V180802E