AGRI-COVER ROLL UP TRUCK BOX COVER Інструкція з монтажу Посібник з монтажу - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні аксесуари AGRI-COVER ROLL UP TRUCK BOX COVER. AGRI-COVER ROLL UP TRUCK BOX COVER 16 сторінок.
Друкувати сторінку
6: INITIAL OPERATION AND ADJUSTMENTS
A. Unroll cover and place rear bar into strikes
on side rails. Press down on rear bar to close
(20-30 lbs pressure). The cover fabric may
be tight. Over time, under tension, it will
conform to its hardware and loosen slightly.
If rear bar is too hard to push down, adjust
tensioners equally as needed to close.
B. Close tailgate slowly, top of tailgate should
fit snug under rear bar. If cover impedes
normal tailgate operation, raise side rails by:
loosening rear clamps, adjusting side rail up
and then tightening clamps. If there is a gap
between tailgate and cover, adjust side rails
lower.
IMPORTANT: Verify each clamp is
torqued to 20 ft-lbs or value specified in
special instructions (if supplied). Start
behind cab and work toward tailgate.
C. Check cover tension by releasing latch
and then opening and closing rear bar
several times. It should snap when closing.
Cover fabric should be tight without sagging
between the bows.
D. If adjustment is needed, roll cover open
then either: turn tension adjuster clockwise
to loosen or turn tension adjuster counter
clockwise to tighten. Ensure to adjust
tensioners equally.
E. Always seal both sides of cover with hook
and loop system. For detailed operating
instructions see pages 12 and 13.
Tip: Reasons to keep cover drum tight:
1. Increases longevity
2. Decreases noise
3. Enhances appearance
10
Nylon strike
at rear
To Loosen Cover
Turn Clockwise
To Tighten Cover
Turn Counter
Clockwise