AGRI-COVER ACI SRT-2 Інструкція з монтажу Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Аксесуари для тракторів AGRI-COVER ACI SRT-2. AGRI-COVER ACI SRT-2 8 сторінок.
Також для AGRI-COVER ACI SRT-2: Інструкція з монтажу Посібник з монтажу (8 сторінок)

Друкувати сторінку

2: ATTACHING MOTOR (Continued)

G. Insert drive shaft on motor into cartridge.

H. Turn roll tube by hand until holes align and

secure with previously removed clevis and

cotter pins. Bend cotter pin tabs.

TIP: Periodically grease motor extension.

NOTE: If lower pivot arm extends past top

of motor in closed position, trim off excess

Then reinsert nylon plug into top of lower

pivot arm.

3: ELECTRICAL

A. Locate and clean suitable locations to apply caution stickers.

B. Refer to included instructions to complete wiring.

INSPECTION AND MAINTENANCE

Periodic preventive maintenance should be practiced:

• Inspect tarp and hardware for abrasions or loosened bolts that may need

adjustment. Adjust tension when needed. Tarp must be kept to a recommended

tension setting equally on both ends, or excessive tarp wear may occur.

• Tarp should always operate as well as when first installed. Make all appropriate

repairs or adjustments immediately before serious damage occurs.

• Check the tightness of mounting bolts and electrical connections, remove any dirt or

corrosion that may have accumulated on the electrical connections.

• Always use genuine Agri-Cover, Inc. replacement parts, use serial number to easily

order replacement tarp.

Clevis pin

Serial number is located at rear

of tarp on stationary tube side

For Replacement: 1-800-233-4655

EZL/ATL Part #: KA-116132A010

SERIAL: 123456789 18.12.2015

Cotter pin

PVC spacer