4ms Company Dual Looping Delay Примітки до випуску - Сторінка 8
Переглянути онлайн або завантажити pdf Примітки до випуску для Обладнання для запису 4ms Company Dual Looping Delay. 4ms Company Dual Looping Delay 10 сторінок.
Також для 4ms Company Dual Looping Delay: Посібник користувача (20 сторінок)
Друкувати сторінку
loudness (logarithmically). That is to say, with Audio Taper, if the Delay Feed knob is at 50% then the audio level
will be 10% (which the ear perceives as half as loud).
In Linear Taper, if the knob is at 50% then the audio level will be 50%.
Previous firmware version had the Delay Feed knob work with an Audio Taper, because that's preferred for most
audio volume knobs since it follows the ear's natural way of perceiving loudness. However with variable Feedback,
Wet/Dry Mix, and multiple channels mixing together, the idea of "natural perception" is out the window. We got
some feedback from users that Delay Feed seemed to make things too quiet too quickly, so the use of Linear
Taper compensates for that. In Version 5, Linear Taper is not the default but can be changed by the user.
With Linear Taper, iIf you have a very hot input signal you should keep Delay Feed below 50% so that it doesn't
saturate
Runaway DC Blocking – NEW FEATURE!
Hardware on the DLD inputs eliminates most DC offset, but it's still possible for a small amount of offset to come into
the systems and problems can occur internally when high feedback magnifies this offset until it causes the whole
output signal to drift up or down and hitting the rails, causing grave distortion
Runaway DC Block protects against this toxic situation, The default is set to 'on' and we recommend not adjusting this
unless you are using the DLD for recording CV sequences with Feedback at or near 0%.