4ms Company WAV Recorder Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису 4ms Company WAV Recorder. 4ms Company WAV Recorder 15 сторінок.
Друкувати сторінкуControls: Button, Knob, Switch and Jacks
Record/Playback switch
Record
The
toggles between these functions.
Flip the switch up to enter
Playback
Button
Record
In
it again to stop recording. The button will turn red while recording.
Play
In
Press it again to stop playing. The button will turn green while playing.
Audio IN jacks
IN
Patch the audio signal you want to record into the
if you patch a mono signal into the
jack, the signal will be routed to both channels. To record a stereo signal, patch into both
Left
Right
IN
modular level.
Audio OUT jacks
OUT
The
to playback of .wav files. The
jack outputs the right channel. The Signal Meter shows the level of the signal present on
these jacks.
Signal Meter
Clip
These eight lights will show the level of the signal being output on the
recording, this is equivalent to the signal being recorded. The left column represents the left
audio channel, and the right column represents the right audio channel. More lights turned on
means there's a louder signal. The top red lights indicate clipping. If the Signal Meter shows
that your signal is either too loud (clipping) or too quiet, you can use the the
adjust the level.
Gain knob
0dB
The volume (level) of the signal being recorded or played can be adjusted using this knob.
Turning the
signal quieter. When the knob is turned all the way to the left, the signal is muted. When the
-∞
knob is pointed directly up, the signal is neither boosted nor cut. When the knob is turned all
+20dB
Input Gain
the way up, +20dB of gain is applied (which is enough to boost a line level signal to a
modular level signal).
Record Trigger jack
This jack accepts a trigger. In
mode, a trigger will make playback start or re-start. The
Record
connect and synchronize your
modules. It also allows you to remotely control recording and playback.
SD Card slot and Busy Light
The
Busy
Insert the end of the card with the shiny pins facing to the left.
The
NEVER REMOVE THE SD CARD OR POWER OFF WHEN THE BUSY LIGHT IS ON!
Always wait until the light is off. The light will turn off after you stop recording or playing.
WAV Recorder
has two main functions: recording and playing .wav files. This switch
Record
mode, press the button once to start recording a new .wav file onto the card. Press
mode, press the button once to play the currently selected .wav file from the card.
Right IN
and
jacks. These jacks accept a wide range of signal levels, from line level up to
Audio OUT
jacks can be used for monitoring the signal while recording and for listening
Gain
knob up will make the output louder, while turning it down will make the
WAV Recorder
records and plays back from a microSD card inserted into the card slot.
Busy
light will turn on whenever the card is being read or written.
mode. Flip the switch down to enter
IN
Left IN
jack and have nothing plugged into the
Left OUT
jack outputs the left channel, and the
Record
mode, a trigger signal will toggle recording. In
WAV Recorder
with a clock, other
Page
3
of
15
Playback
jacks. The jacks are normalized so that
OUT
jacks. If you are
Gain
Record Trigger
jack allows you to
WAV Recorders
mode.
Right IN
Left
Right OUT
knob to
Play
or other