Auslock T11 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Замки. Auslock T11. Auslock T11 13 сторінок. Smart dead lock

4.FAQ

1) How to read operation records?

2) Why can't I unlock it after open the passage

mode

3) What is the purpose of Auto Lock

4）After installation, touch sensing keyboard,

screen no respond

5）Unable to register fingerprint

6）What is the reason why the smart lock

consumes fast power?

7）There is no response to pressing the handle

on outside the door, and there is unlock normally

on inside the door, but the verification is normal,

and the motor is normal.

8）How many times will the password be

locked? How long is it locked?

In the Records of the main interface. .

You need to perform an unlock verification in any

method, than the passage mode will take effect.

You can set how long to lock after unlocking

a) In this case, first check that the positive and

negative electrodes of the battery have been

installed upside down, whether the battery has

enough power

b) Remove the back panel and see if it's connected.

c) To eliminate the above situation, you need to

remove the lock ,check whether the wires of the

lock body are squeezed, and the re-wire.

Check the fingers for dirt or wear, check the fingerprint

head on the lock for dirt and oil stains, etc.

Check to see if the fingerprint is working

properly(Press to see if there is any responds.

a) Large standby power consumption

b) Short circuit

It may be the triangle direction on the clutch was error,

please check correction.

Enter the wrong password more than 5 times in a row,

the keyboard is locked for 5 minus, Other ways to can

open the door