DataStor Compaq Proliant Ultra2 SCA Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Зберігання DataStor Compaq Proliant Ultra2 SCA. DataStor Compaq Proliant Ultra2 SCA 2 сторінки. 80pin hot plug tray

Друкувати сторінку

Connect Drive to SCA 80pin connector

1. Connect the SCA 80pin connector on your drive to the SCA

80pin connector in the tray

2. Referencing the documentation that came with your

drive, be sure to Disable any automatic or passive drive

termination features on the drive itself.

Select and Attach Cover Grill to Tray

1. Select and attach the appropriate cover grill to your tray. This

selection will depend on the format of drive you are using as

well as your current Proliant

2. The cover grill attaches by inserting the four feet on the

bottom of the cover through the Tray Cover Slots (Figure 2) and then sliding the cover forward so that the

front, beveled part of the cover is flush with the beveled portion of the tray.

3. The cover can be further secured by mounting two screws through the side mounting holes on the sides of

the cover to the appropriate mounting holes in your drive, if available.

Insert Tray into Receiving Cage

1. Referencing Figure Four, apply pressure between your thumb and forefinger on the tray release levers on

the front of the tray. This should allow the levers to swing out, thus allowing you to slide the tray into the

receiver on your server.

2. Gently slide the tray into the receiver until you feel the PCB connector on the back of the tray touch the

connector.

3. Rotate the Release Levers back into the locked position. You should hear and feel a click when the levers

lock into place. This should force the tray completely into the receiver connector and snugly lock the tray into

the server.

DataStor, 12601 Monarch Street, Garden Grove, CA 92841-3918

Phone (800) 777-6621 / Fax: (714)833-9600 / Web Site: www.dstor.com

Installation Guide - Hot Plug Tray, Ultra2 SCA 80pin, Compaq Proliant , Rev 1.0 - August 1999 - P/N CQPTSCA

Copyright 1999 by DataStor, Inc. All rights reserved. No part of this document may be reproduced in any form without prior written consent from DataStor. The information and specifications in this document are subject to change

without notice. Changes to this document are incorporated in new versions. DataStor, and the DataStor logo are reqistered trademarks of DataStor, Inc. Other trademarks used herein are the property of their respective owners.

tray receiver configuration.

Compaq

and Proliant

are both Trade Marks of Compaq Computer Corporation.

This document was printed in the United States Of America.

Figure 3

Tray Release Levers

Close-Up View

Figure 7