Agri-Fab 45-02104 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-02104. Agri-Fab 45-02104 13 сторінок. Agri-fab 125 lb. push broadcast spreader owner's manual
Друкувати сторінкуIMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.
9.
Place the long handle tube onto the crossover tube
on the side opposite from the shaft support plate.
Fasten with the bolt, washer and nut removed in the
previous step. See figures 4 and 5. Do not tighten
at this time.
10. Assemble two handle braces to the inside of the hopper
frame, one on each side, using two 1/4" x
bolts and two 1/4" nylock nuts. See figure 5. Do not
tighten at this time.
11. Assemble the other end of the two handle braces to
the long handle tube using a 1/4" x 1-1/2" hex bolt and
1/4" nylock nut. Do not tighten at this time.See figure
5.
12. Tighten all nuts and bolts in same sequence as
assembled in steps 9 through 11. See figure 5.
HANDLE TUBE (LONG)
HEX BOLT
1/4" x 1-1/2"
1/4"
NYLOCK
NUT
MIDDLE
BOLT
FIGURE 5
1-1/2" hex
HITCH
BRACE
HEX BOLT
1/4" x 1-1/2"
MIDDLE
NUT
CROSSOVER
TUBE
SHAFT
SUPPORT
PLATE
13. Assemble the leg stand tube to the handle tube (long)
using two 1/4" x 1-1/2" hex bolts. Secure tightly with
two 1/4" nylock nuts. See figure 6.
14. Place a vinyl cap over the end of the leg stand tube.
See figure 6.
HANDLE TUBE (LONG)
1/4"
NYLOCK
NUTS
VINYL CAP
FIGURE 6
15. Assemble the flow control link (end with small hole)
to the flow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock nut as shown in figure
7. Tighten carefully. The flow control link should not
be loose but should pivot with no more than slight
resistance.
FLOW CONTROL
LINK
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7
5
1/4" x 1-1/2"
HEX BOLTS
LEG STAND TUBE
FLOW
CONTROL
1/4"
NYLOCK
NUT
ARM