Agri-Fab 45-02141 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-02141. Agri-Fab 45-02141 12 сторінок. Broadcast spreader 100 (push)
Також для Agri-Fab 45-02141: Посібник користувача (13 сторінок)
Друкувати сторінкуASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)
Pliers
(1)
Hammer
(2)
7/16" Open or Boxed End Wrenches
1.
Remove the spreader, the loose parts and the hard-
ware package from the carton. Lay out parts and
hardware and identify. Refer back to figures 1 and 2.
2.
With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 1/2" flat
washer onto each end of the axle. See figure 3.
AXLE
SPACER
1/2" FLAT
WASHER
FIGURE 3
3.
Place a wheel onto the end of the axle that has no cross
hole. The long end of the hub goes to the inside. See
figure 4.
4.
Place a 1/2" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 4.
NO CROSS HOLE
WHEEL
FIGURE 4
1/2" FLAT
WASHER
HUB CAP
5.
Place a wheel onto the end of the axle that has a cross
hole. The long end of the hub goes to the inside. See
figure 5.
6.
Assemble a 5/32" x 2" cotter pin through the notched
wheel hub and the axle. See figure 5.
7.
Lightly tap a hub cap onto the axle until it is snug
against the wheel. See figure 5.
FIGURE 5
8.
Remove the 1/4" hex bolt, flat washer and hex lock nut
from the center of the crossover tube. See figure 6.
CROSSOVER
TUBE
1/4" FLAT
1/4" HEX
WASHER
LOCK NUT
FIGURE 6
4
5/32" x 2"
COTTER PIN
CROSS
HOLE
WHEEL
1/4" HEX
BOLT
SHAFT
SUPPORT
HUB CAP