Agri-Fab 45-02143 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-02143. Agri-Fab 45-02143 12 сторінок. Agri-fab 100 lb. push broadcast spreader owner's manual
Друкувати сторінкуASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(1) Hammer
(2) 7/16" Open or Boxed End Wrenches
1.
Remove the spreader, the loose parts and the hardware
package from the carton. Lay out parts and hardware
and identify using the illustrations on pages 2 and 3.
2.
With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 1/2" flat
washer onto each end of the axle. See figure 1.
AXLE
SPACER
1/2" FLAT
WASHER
FIGURE 1
3.
Place a wheel onto the end of the axle that has no
cross hole. The long end of the hub goes to the inside.
See figure 2.
4.
Place a 1/2" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 2.
NO CROSS HOLE
WHEEL
FIGURE 2
1/2" FLAT
WASHER
HUB CAP
5.
Place the drive wheel onto the end of the axle that has
an indent. The long end of the hub goes to the inside.
See figure 3.
6.
Lightly tap a hub cap onto the axle until it is snug against
the wheel. See figure 3.
FIGURE 3
7.
Remove the middle 1/4" hex bolt, flat washer and hex
lock nut from the crossover tube. See figure 4.
CROSSOVER
TUBE
MIDDLE BOLT
& WASHER
FIGURE 4
4
HUB CAP
WHEEL
MIDDLE NUT
SHAFT
SUPPORT
PLATE