Aussie Pumps QP-60TDK/D1105 Посібник з експлуатації та деталей - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації та деталей для Водяний насос Aussie Pumps QP-60TDK/D1105. Aussie Pumps QP-60TDK/D1105 20 сторінок. Trash pump
Друкувати сторінку ALWAYS read, understand, and follow procedures in
Operator's Manual before attempting to operate
equipment.
ALWAYS be sure the operator is familiar with proper
safety precautions and operation techniques before
using pump.
ALWAYS store equipment properly when it is not
being used. Equipment should be stored in a clean,
dry location out of the reach of children.
NEVER pump volatile, explosive, flammable or low
flash point fluids. These fluids could ignite or explode.
NEVER
operate
atmosphere.
ALWAYS ensure pump is on level ground before use.
Become familiar with the components of the pump
before operating.
ALWAYS replace any worn or damaged warning
decals.
NEVER pump corrosive chemicals or water containing
toxic substances. These fluids could create serious
health and environmental hazards. Contact local
authorities for assistance.
NEVER open the priming plug
when pump is hot. Hot water inside
could be pressurized much like the
radiator of an automobile. Allow
pump to cool to the touch before
loosening plug. The possibility
exists of scalding, resulting in
severe bodily harm.
NEVER block or restrict flow from discharge hose.
Remove kinks from discharge line before starting
pump. Operation with a blocked discharge line can
cause water inside pump to overheat.
ALWAYS fill the pump casing with water before
starting the engine. Failure to maintain water inside
the pump housing will cause severe damage to the
pump.
In winter drain water from pump housing to prevent
freezing.
QP60TDK SERIES TRASH PUMP• OPERATION AND PARTS MANUAL — REV. #0
the
pump
in
an
explosive
ALWAYS make sure that the pump's trailer is placed
on solid level ground so that it cannot slide or shift
around, endangering workers. Deploy jack stands for
stabilization. Place blocks under the trailer's bumper to
make it level (prevents tipping), and use a chocked
block underneath the wheels to prevent rolling. Also
keep the immediate area free of bystanders.
Before starting the pump, check that the clean-out
cover is securely fastened.
NEVER start the pump with the clean-out cover
removed. The rotating impeller inside the pump can
cut or sever objects caught in it.
RULES & REGULATIONS
PAGE 7