Aussie Pumps Eco Clean Super Indy Інструкція з експлуатації та обслуговування - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Ультразвуковий очищувач ювелірних виробів Aussie Pumps Eco Clean Super Indy. Aussie Pumps Eco Clean Super Indy 20 сторінок. High pressure washer

Друкувати сторінку

USING

THE CLEANER

CONTROL PANEL

A - On/off switch

B - Temperature regulator

C - Detergent control tap (if

available).

D - Pressure gauge.

STARTING THE CLEANER

1) Turn on the water supply tap (fig. 5A).

2) Connect the water cleaner to the mains electricity supply via

the omnipolar switch or by plugging the plug into the socket.

3) Start the cleaner by turning the selector switch to pos. 1

(fig. 7A).

The high pressure water jet generates a reaction force in the

lance. Keep a firm grip on the lance handle.

4) Press the trigger on the gun and begin washing.

5) To use the cleaner with hot water, turn the temperature regu-

lator (fig. 7B) to the recommended washing values.

For some models turn the ignition switch (fig. 7A) onto the

hot water position before effecting the operations described

in this point.

In water cleaners with the "Total Stop" system, the motor

starts and stops when the lever on the lance handle is actioned

or released.

Do not tie the gun trigger in the delivery position.

IMPORTANT!

To eliminate any impurities

or air bubbles from the wa-

ter circuit we advise starting

the cleaner for the first time

without the lance and letting

the water run out for a few

seconds.

Impurities could block the

nozzle and cause malfunc-

tion (Fig. 8).

FIG. 7

FIG. 8

Aussie Eco-Clean Super Indy Operating & Maintenance Manual 2020

STOPPING THE CLEANER

1) Switch off the burner by

turning the pressure regulator

to pos. "0" (fig. 7B).

2) Let the cleaner run with

cold water only for at least

30 seconds to cool down the

boiler.

3) After using with detergent,

flush out the inlet; place the

detergent suction hose (fig.

9) in a tank of clean water and

let the pump run for 1 minute

with the dosing tap turned fully

on and the lance in detergent

delivery condition.

4) Stop the cleaner by turning

the selector switch to pos. "0"

(fig. 7A).

5) Discharge the pressure

from the H.P. hose by pressing

the trigger on the gun

Disconnect the water clea-

ner from the mains electricity

supply via the omnipolar

switch or by unplugging the

plug from the socket.

7) Turn off the water supply

tap (fig. 5A).

If the water cleaner is left,

even temporarily, turn it off by

using the omnipolar switch or

by unplugging the plug from

the socket.

Water cleaners with the

"Total Stop" device should

be considered as off when

the omnipolar switch is in

the "O" position or the plug is

unplugged from the socket.

When the water cleaner

is not used, close the safety

device on the handle.(fig.11)

Dry use of the water

cleaner causes serious dam-

age to pump gaskets.

FIG. 9

FIG.11