AUSSIE TONNEAU ATB01152 Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Автомобільні аксесуари AUSSIE TONNEAU ATB01152. AUSSIE TONNEAU ATB01152 4 сторінки. Tonneau cover to suit triple m 2400 x 1712mm

Друкувати сторінку

TONNEAU COVER FITTING INSTRUCTION

TONNEAU COVER TO SUIT TRIPLE M 2400 X 1712MM

BASIC TOOL REQUIRE

Rivet gun, Drill, 4.5mm Drill Bit, Measuring Tape, Silicon Sealant, Anti-Corrosive Primer,

Marking Pencil

CONTENTS

1 x Tonneau Cover

2 x Tonneau Support Bar

2 x Aluminium Ropetrack

1 x Fitting Instruction

1. INSTALLATION PROCEDURE

Note: Remove swarf and apply rust inhibitor to all drilled holes prior to riveting.

1. Join 2 or 3 pieces of rope track with dowel supplied. Place 1 piece of dowel in each end of the

joined rope track.

2. Place the rope track with dowel placed in the ends of the rope track on the top edge of the

drop sides and push up against the front vertical edge of the tray. This is to ensure the rope

track is at the correct height and the front bead of the Tonneau cover can slide through from

the side. Refer Diagram A.

3. Using a 4.5mm drill bit, drill six holes through the aluminium rope track and into the front face

of the tray; one at 50mm from either edge, with the others evenly spaced between the outer

two positions. Remove rope track and run a bead of silicone along the flat edge of the rope

track, then rivet the aluminum rope track into position.

4. To install your support bar. Measure the inside length of the tray. If you have been supplied 1

bar, halve this measurement and that is the support bar position. If you have been supplied 2

bars divide the measurement by 3 and these are the support bar positions. Centrally locate

each bar bracket over these positions 5mm down from the top edge, drill and rivet the bar

brackets into place. Repeat for the remaining bar brackets on both sides of the tray. Fit the

Tonneau support bar/s to the bar brackets. (See Multi-Fit Bar Instruction overleaf)

5. Slide the front of the Tonneau cover through the aluminum rope track section. Neatly spread

the Tonneau cover over the support bar/s, so it is centered and fully covers the tray.

PART NUMBER: ATB01152

4 x Bar Brackets

43 x Rivets

4 x Dowels

27 x Rope Buttons