AUSSIE TONNEAU ATB01233 Інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Автомобільні аксесуари AUSSIE TONNEAU ATB01233. AUSSIE TONNEAU ATB01233 3 сторінки. Tonneau cover for isuzu d-max my15-5 dual cab with headboard
Друкувати сторінку
3.3 FITTING MULTI SUPPORT BAR
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket
holders with the holes facing to the ground (so the grub screws don't rub against the tonneau),
as shown above and then with a white pencil make a mark through the small holes of the
hollow bar onto the solid ends. This is where you will drill a hole to the depth of about 1-2mm
(do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes
that you drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may
kink the bar in the middle to give it some extra height to assist with water runoff.