Agri-Fab 45-0324 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-0324. Agri-Fab 45-0324 13 сторінок. Atv mounted 125 lb. broadcast spreader
Також для Agri-Fab 45-0324: Посібник користувача (12 сторінок)
Друкувати сторінку14. Placethe motorassemblydown into the hopper,
inserting thespreader s haftthrough theplasticbush-
ing in the bottomof the hopper.Fastenthe motor
mount b racket t othehopper u singfour5/16"x 1"hex
bolts,5/16"flat washers,nylonwashersand5/16"
nylocknuts.Seefigure8.
15. Slidethe sealdownthe spreadershaftagainstthe
topof the hopperbushing. S eefigure8.
5/16" NYLOCK NUT
SEAL
\
5/16" x 1"
HEX BOLT
WASHER
5/16"FLAT
WASHER
FIGURE 8
17. Slide the impeller
up onto the spreader
shaft and
secure it with a 1/8" x 1-1/4" cotter pin. See figure 9.
IMPELLER
1/8" x 1-1/4"
COTTER PIN
FIGURE 9
18. Attach the flow control to the motor mount bracket on
the spreader
using the 5/16" x 1" carriage
bolt, a
mounting clamp and a plastic knob. See figure 10.
NOTE: You can also attach to the rear rack if you use a
5/16" x 1-3/4" carriage bolt. If you attach to the rear
rack, you can loosely pre-assemble
the clamp, bolt
and knob to the flow control. The clamp can then be
angled down through the slot in the rack.
PLASTIC
KNOB
MOUNTING
CLAMP
5116" x 1"
I
CARRIAGE _......_ _
BOLT
I
L_ _ _
i¸ !
I
ii
5/16" x 1-3/4"
CARRIAGE
BOLT
FIGURE 10