Frigidaire 242063600 Важливі інструкції з техніки безпеки - Сторінка 6
Переглянути онлайн або завантажити pdf Важливі інструкції з техніки безпеки для Холодильник Frigidaire 242063600. Frigidaire 242063600 20 сторінок. Frigidaire refrigerator use & care guide
Друкувати сторінку
INSTALLATION
Door Opening
NOTE
The refrigerator doors are designed to shut by
themselves within a 20 degree opening.
Your refrigerator should be positioned to allow easy
access to a counter or table when removing food. For
best use of drawers and freezer baskets, the refrigerator
should be in a position where both the refrigerator and
freezer doors can be fully opened.
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest firmly on
the floor.
• The cabinet should be level at the front and rear.
• The sides should tilt ¼ inch (6 mm) from front to
back (to ensure that doors close and seal properly).
• Doors should align with each other and be level.
All of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers:
1 Open both doors and remove the toe grille (see
"Toe Grille Installation and removal" in the
"Installation" section).
2 Close the doors and use a flat-blade screwdriver or
/
inch socket wrench to raise or lower the front
3
8
rollers.
3 Ensure both doors are bind-free with their seals
touching the cabinet on all four sides.
6
To level the doors using the adjustable lower
hinge (some models):
1 Before leveling either door, remove set screw that
locks door height into position. (The door cannot
be adjusted without set screw removed).
2 If the refrigerator door is lower than the freezer
door, raise the refrigerator door by turning the
adjustment screw clockwise using a
wrench. (See illustration.)
3 If the freezer door is lower than the refrigerator
door, raise the freezer door by turning the
adjustment screw clockwise using a
wrench. (See illustration.)
4 After leveling, verify door stop contacts lower hinge
and top of door does not contact upper hinge
through full movement of door (from fully closed to
fully open).
5 Reinstall set screw, locking the door height.
7/16" Wrench
and 3/32" Hex Key
Door Stop
(some models)
Flange
6 Replace the toe grille by fitting it into place
(see "Toe Grille Installation and Removal" in the
"Installation" section).
/
inch
7
16
/
inch
7
16
Open Door
Hinge
Flange
Set Screw
(some models)
Hinge