Datavideo RMC-180 Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Контролер Datavideo RMC-180. Datavideo RMC-180 19 сторінок. Ptz camera control unit
Також для Datavideo RMC-180: Інструкція з експлуатації (13 сторінок), Інструкція з експлуатації (16 сторінок), Інструкція з експлуатації (16 сторінок)

RJ-45 ports to connect cameras A, B, C & D

Four RJ-45 ports are provided on the RMC-180 rear to

connect PTZ cameras. The communication protocol is RS-

422, so use any RJ-45 cable to connect the RMC-180 to the

RS-422 port located on the PTC-150 rear panel. However,

before connecting the camera to these channel ports,

please set the bit 4 of the camera DIP switch located at the

bottom to OFF.

Note: Max allowable cable length is 300 m.

Tally Input

The RMC-180 has the ability to receive tally signals from

Datavideo Switchers such as the HS-2000 or HS-2200. Upon

receiving the video switcher's tally output signals, the

corresponding Tally LED indicator on the RMC-180 keyboard

will be turned ON, giving the operator an indication of

which camera is currently live at the switcher end.

DC In Socket

Connect the supplied 12V 0.5A PSU to this socket. The

connection can be secured by screwing the outer fastening

ring of the DC In plug to the socket.

Power On/Off Switch

Switches the device ON / OFF.

Grounding Terminal

When connecting this unit to any other component, make

sure that it is properly grounded by connecting this terminal

to an appropriate point. When connecting, use the socket

and be sure to use wire with a cross-sectional area of at

least 1.0 mm