Cooke & Lewis 3663602842088 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Варильна поверхня Cooke & Lewis 3663602842088. Cooke & Lewis 3663602842088 12 сторінок.

Gas connection

WARNING: The connection of the hob to the gas network or gas cylinder must be made by means

of a rigid copper or steel pipe with fittings complying with local regulations. These fittings are NOT

supplied. THIS OPERATION MUST BE MADE BY A QUALIFIED GAS INSTALLER.

A connecting elbow is pre-fitted to the hob. This elbow terminates in an external 1/2" BSP connecting

thread complying with ISO 228-1:2003. The connection made to the pre-fitted elbow MUST be

suitable for connecting to this thread. If ANY other connection type or thread size is used a suitable

adaptor MUST be fitted.

The qualified gas installer must ensure that the operation of the burners has been correctly verified

before use.

CAUTION: The gas connection must be installed in compliance with applicable regulations in the

country of installation.

Gas supply requirements

The appliance installation must be carried out in accordance with relevant local regulations.

The installation must be carried out by an authorised gas appliance installer and tested to

local regulations.

We are not legally able to offer advice on the installation of gas appliances to

un-authorised personnel.

Ventilation

This appliance must not be connected to a combustion products evacuation device. It shall be

connected and installed in accordance with local installation regulations paying particular attention to

the relevant requirements regarding ventilation.

What to do if you smell gas?

Do not try to light any appliance.

Do not touch any electrical switch.

Do not use phones in the building.

Immediately call your gas supplier from a different property.

WARNING: Read the instructions before using the appliance.

THIS APPLIANCE MUST BE EARTHED.

THIS HOB MUST BE INSTALLED BY A QUALIFIED GAS TECHNICIAN!

All installation must be carried out by a qualified electrician. Before connecting the mains supply

ensure that the mains voltage corresponds to the voltage on the rating plate.

Direct Connection

The appliance must be connected directly to the mains using an omnipolar circuit breaker with a

minimum opening of 3 mm between the contacts.

The installer must ensure that the correct electrical connection has been made and that it complies

with the wiring diagram.

The cable must not be bent or compressed.

TRAG10782 200000001A SM Cooke and Lewis 2 Zones Gas V7b R.indd 4

12/06/2017 15:09